The VIPER pre-cut pinewood derby car is another masterpiece pinewood derby design. It is modeled after a futuristic sports car.

- Made from a standard BSA block. Master craftsman, PineMasters, shaped the block then added the side fenders and decorative pieces.
- Includes pre-cut milled cavity (3 3/4" x 1 1/4" x 1/4" deep) on the bottom for weights. You will need a good epoxy to secure weight into this cavity.
- Dimensions are legal in any pinewood derby race.
Car is 7" long by 2 1/2" wide
Car has axle slots on the bottom with standard 4 3/8" spacing


Note: The VIPER is a pre-cut car block only. It is unpainted and does not include wheels or axles.


The approximate weight of this car is 2.4 oz, plus or minus .2 oz.
BSA wheels and axles weight about .5 oz, so you will need about 3 to 3.5 oz extra weight for this car.

- Make this car your own, and send pictures to info@pinewoodpro.com and we'll put it on our Picture Gallery page!