NASCAR pinewood derby car
In Stock Ready to Ship!
This item qualifies for Free Shipping on orders over $75
4.7 out of 5 stars
This car includes pre-drilled 3/8" weight holes in the rear and in the wheel wells for zinc, composite, or tungsten 3/8" cylinder weights.
The axle slots are also pre-drilled so you can easily insert your axles.
The NASCAR is cleanly cut. You can give it a light sanding to make it perfectly smooth or paint it as is.
The approximate weight of this car body is 3.6 oz, plus or minus .4 oz.
You will need about .5oz to 1.8 oz extra weight for this car.
We recommend using a sanding sealer base before painting.
The NASCAR has fenders that go over the wheel wells. Fenders are usually allowed in all race rules, but check with your race manager to be sure. The fenders do not extend past the width of the car with the wheels installed.
The block dimensions are 7" long x 2.5" wide x 1.5" high
This car also has drilled axle holes, not axle slots. Again, most race rules allow drilled axles holes, but some require that you use the axle slots.
Product Code: 061811